Search results

//Timeout! Signal used to disable sound generation is setting cntAC to max.

...tput component video that could be fed to an upscaler that generated a VGA signal. I already picked up a small VGA monitor, but for MSXGOTO40 this solution == The adapter works and gives a good VGA signal ==

...d if you looked carefully you could also see intensity faults in the video signal. I decided that combining the power and signal ground wires was a bad idea, and decided that adding a fifth wire was a nec

*an ethernet PHY that does the actual ethernet analog signal conversion

...e memory, sensors and processing capability. The chip communicates using 1 signal and 1 ground wire, connected to the top and sides of the can. By pressing t

* With three waveforms around the ring, the ring represents 60 ms of mains signal

//Timeout! Signal used to disable sound generation is setting cntAC to max.

Mod by Morphje: Range increased to 400+ meter open air range. Signal quality on IBM laptop was 43% @ 400 meter.

# Compatible with modern TV's thanks to better digital sync signal generation, giving sharp stable and high contrast pictures. # Composite video (PAL or NTSC) output signal instead of RF signal, for even sharper picture, compatible with yellow RCA inputs, and SCART

...hat are between the DAC and the amplifier to make this a combined low+high signal.

...EXOR as during VSYNC HSYNC pulses actually appear as inverted in the VSYNC signal, but perhaps I should check my logic here carefully. ..., I corrected some labels where I used the backslash to denote in inverted signal, instead of the lowercase "n" I used everywhere else.

* The lamp determines its location by based on signal strength and BSSID of nearby WiFi base stations.

...ro controller and a tiny bit of hard and software you could create a video signal. And Jim had come up with his own similar scheme that would only use as muc

...ro controller and a tiny bit of hard and software you could create a video signal. And Jim had come up with his own similar scheme that would only use as muc

...ot for each GPIO pin, as a limitation that prevented it to generate an SPI signal using the AY-3-8912 GPIO's.This was a problem as turning the GPIO's to inpu

...NEC, and sends a 32-bit code for the first press, and then 0-bit codes to signal the same key is still down. As usual only the lower 4 bits seem to be varia

The I2S clock signal is 64 times higher than the sample clock, so at a sample rate of 44100 Hz,

...clock out a video stream, to try to generate a 320 x 200 (monochrome) VGA signal, using a Arduino nano as a CRTC surrogate. Then continue from there. Also these tech-demo's create a quite a low resolution video signal, which doesn't satisfy me.

...evspace.nl/User:Mux mux]. By request you can get his e-mail, phone number, Signal, Hangouts, whatever you like. Just ask on IRC or in person, or any other wa

...ing in black sections of the video traces at random locations in the video signal. The only other system that had no video arbitration logic AFAIK was the or