Search results

At the top of the spectrogram you see the data portion of the signal, consisting solely of up-chirps. ...ed by a Semtech chip. This allows for a more compact representation of the signal for analysis.

** hansg: support voor image signal processor (camera) in favoriete skere tabletSoCjes, nog maar ~200 patches t

It appears the Altera chip drives two 245 chips which in turn drive the signal to the connector J1 to the LED board. * J1.1: IC2.A1 -> IC2.B1 -> via ... -> SRCLK signal of both column shift registers

...hat the ADS-B signal arrived at the different receiver stations (the radio signal moves at the speed of light!).

| 1N4148 || 500 || small signal diode || 368106 || 2.00 |BC547 || 200 || small signal NPN BJT, higher voltage then BC558 || || || availible need to count

...room antenna, to transmit a low-power GNSS signal that is a copy of a GNSS signal picked up on the roof. The signal is intended only for devices present in the room.

...t is still quite finicky and still not sensitive enough and needs a lot of signal to work properly.

* SCL signal from I2C * SDA signal from I2C

* 9 Sep 2010 - Broadcast [[http://signal.hackerspaces.org/ Signal]] Hackerspace Hour

* PWM, the laser tube intensity signal A low-pass filter is needed to average the PWM-signal before measuring it.

A signal that is reflected by an object in the view of the radar, will arrive back a Because of the delay, the outgoing signal will have already changed in frequency compared to the incoming reflected f

...measurement of the VL53L0X module is based on time-of-flight of the laser signal reflecting off a surface. ..." of 0.25 (I guess this is a measure for the amplitude of the laser return signal)

...for the people looking to quantize frequency response, but the space has a signal generator for that.

...noise in the earpiece that disappears when you probe either a low or high signal, and the yellow LED then turns off too. Connecting it via some impedance to

...sty pulses a diode detector is used. The next NAND buffers and inverts the signal. Here we have a nice continuous HIGH level when the soil is too dry and a L

Sending power signal to pin: 6

...formation about the particular gateway that received your signal, received signal strength and with what settings (bandwidth, spreading factor) your packet w ...feature (which is AFAIK not used in LoraWAN), I guess you can ignore that signal.

...ed that the LM386 speaker driver used to buffer/amplify the Cassette input signal was completely unnecessary. All Barrel and jack plug connectors were replac ...h to another game to load, and J3 is to start playback. J4 is the cassette signal output, internally connected to the EAR input jack. J5 is not used in a Spe

...across the diode, which is then amplified by a jfet and a dual opamp. This signal is fed into the comparator, triggering an LED and causing the buzzer to emi

...imal bat call recorder: just add an analog preamplifier for the ultrasonic signal (+ a lot of software!).