Search results

...EXOR as during VSYNC HSYNC pulses actually appear as inverted in the VSYNC signal, but perhaps I should check my logic here carefully. ..., I corrected some labels where I used the backslash to denote in inverted signal, instead of the lowercase "n" I used everywhere else.

* The lamp determines its location by based on signal strength and BSSID of nearby WiFi base stations.

...ro controller and a tiny bit of hard and software you could create a video signal. And Jim had come up with his own similar scheme that would only use as muc

...ro controller and a tiny bit of hard and software you could create a video signal. And Jim had come up with his own similar scheme that would only use as muc

...ot for each GPIO pin, as a limitation that prevented it to generate an SPI signal using the AY-3-8912 GPIO's.This was a problem as turning the GPIO's to inpu

...NEC, and sends a 32-bit code for the first press, and then 0-bit codes to signal the same key is still down. As usual only the lower 4 bits seem to be varia

The I2S clock signal is 64 times higher than the sample clock, so at a sample rate of 44100 Hz,

...clock out a video stream, to try to generate a 320 x 200 (monochrome) VGA signal, using a Arduino nano as a CRTC surrogate. Then continue from there. Also these tech-demo's create a quite a low resolution video signal, which doesn't satisfy me.

...evspace.nl/User:Mux mux]. By request you can get his e-mail, phone number, Signal, Hangouts, whatever you like. Just ask on IRC or in person, or any other wa

...ing in black sections of the video traces at random locations in the video signal. The only other system that had no video arbitration logic AFAIK was the or

...a Covox Speech Thing clone, but less ugly. The output is a pure line level signal. It won't drive headphones and really needs an amplifier. But it works grea

...same one as used in the Vortex. Would be good to figure out if the 'busy' signal and/or the serial TX are connected back to the arduino somewhere in that ca