ZigbeeCoordinator

Project ZigbeeCoordinator
File:NoPicture.jpg
Flashing a CC2531 USB dongle with Zigbee coordinator firmware
Status	In progress
Contact	bertrik
Last Update	2019-03-10

What

This page describes the steps I performed to flash a generic CC2531 USB stick with firmware to make it act as a Zigbee coordinator. Zigbee is a wireless protocol to communicate with wireless appliances in your home, for example Ikea TRADFRI lamps.

Steps to do:

• buy the hardware, i.e. the CC2531 stick and the adapter cable
• wire up an ESP8266 Wemos D1 mini as a programmer
• build the ESP8266 Arduino sketch
• download, build and run the programmer utility

Hardware

I ordered this CC2531 stick

This was connected to an ESP8266 Wemos D1 mini for programming.

I wired this up as follows:

• press the flatcable onto the stick, with the red wire away from the USB connector
• press the flatcable onto the programming adapter, with the red wire towards pin 1

Wiring up:

• Wemos D1 pin GND -> breadboard -> adapter GND (pin 1)
• Wemos D1 pin D8 -> breadboard -> adapter RESETn (pin 7)
• Wemos D1 pin D7 -> breadboard -> adapter DC (pin 3)
• Wemos D1 pin D6 -> breadboard -> adapter DD (pin 4)
• Wemos D1 pin D5 -> breadboard connected to D6!

I downloaded the CCLib toolchain from GitHub.