Packet radio: Difference between revisions
No edit summary |
No edit summary |
||
| Line 9: | Line 9: | ||
Tsja, 1200 baud… Gewoon omdat het kan! | Tsja, 1200 baud… Gewoon omdat het kan! | ||
---- | <strike>---- | ||
Direwolf 1.3 - TX beacon voor nu - binnenkort audio-in klussen! | Direwolf 1.3 - TX beacon voor nu - binnenkort audio-in klussen!</strike> | ||
| Line 29: | Line 29: | ||
==Hardware== | ==Hardware== | ||
We have an [http://tnc-x.com/TNCPi.htm TNC-PI] which is a TNC connected to a Raspberry Pi interfaced to a Midland Alan 48 plus (27 MHz) radio. | |||
Every five (5) minutes it sends out a beacon of information about the setup and the request to report back any receptions. Any incoming packets are being logged to the disk. If an incoming packet appears to be an APRS packet, it should get digipeated. | Every five (5) minutes it sends out a beacon of information about the setup and the request to report back any receptions. Any incoming packets are being logged to the disk. If an incoming packet appears to be an APRS packet, it should get digipeated. | ||
Revision as of 10:55, 8 April 2016
| Project Packet radio | |
|---|---|
| hoe meer elektromagnetische velden, hoe meer vreugd | |
| Status | In progress |
| Contact | Flok420, Maxell, Crashjuh |
| Last Update | 2016-04-08 |
Tsja, 1200 baud… Gewoon omdat het kan!
----
Direwolf 1.3 - TX beacon voor nu - binnenkort audio-in klussen!
Networking
packetacer laptop: revspace@2001:610:76a:0:c646:19ff:fe57:e595
Currently the rpi is connected to a gl-inet (owned by Flok). The gl-inet is a client for revspace-pub. The gl-inet has a port-forward to the rpi.
IP address of the gl-inet: 10.42.43.253.
MAC address of the gl-inet: e4:95:6e:40:2c:34
MAC address of the raspberry pi: b8:27:eb:2b:a2:f9
The RPI can be accessed from RevRadio2 via IP address 172.19.0.9 - this IP address is part of the liberreto TINC vpn mesh network.
Hardware
We have an TNC-PI which is a TNC connected to a Raspberry Pi interfaced to a Midland Alan 48 plus (27 MHz) radio. Every five (5) minutes it sends out a beacon of information about the setup and the request to report back any receptions. Any incoming packets are being logged to the disk. If an incoming packet appears to be an APRS packet, it should get digipeated.
old settings for the radio
oude todo
- Anti-kabelsalade keuze: installatiekast
- Hier een mooie aan uit knop op voor als de zender uit moet (maar rpi aan mag blijven)
- Anti-kabelsalade keuze: installatiekast
- Add functionality
- APRS iGate: send all incoming aprs packets to cbaprs.de
- Direwolf sound card tnc?
- MQTT gateway rx/tx
- APRS iGate: send all incoming aprs packets to cbaprs.de