Packet radio: Difference between revisions
No edit summary |
|||
| (8 intermediate revisions by 3 users not shown) | |||
| Line 8: | Line 8: | ||
}} | }} | ||
Tsja, 1200 baud… Gewoon omdat het kan! | |||
<strike>---- | |||
Direwolf 1.3 - TX beacon voor nu - binnenkort audio-in klussen!</strike> | |||
== Networking == | == Networking == | ||
packetacer laptop: revspace@2001:610:76a:0:c646:19ff:fe57:e595 | |||
---- | |||
<strike> | |||
Currently the rpi is connected to a gl-inet (owned by [[Flok]]). The gl-inet is a client for revspace-pub. The gl-inet has a port-forward to the rpi. | |||
IP address of the gl-inet: 10.42.43.217 | |||
MAC address of the gl-inet: e4:95:6e:40:2c:34 | |||
</strike> | |||
Currently the rpi is connected directly to the revspace network. | |||
IP address of the raspberry pi: 10.42.43.49 | |||
MAC address of the raspberry pi: b8:27:eb:2b:a2:f9 | MAC address of the raspberry pi: b8:27:eb:2b:a2:f9 | ||
The RPI can be accessed from [[RevRadio2]] via IP address 172.19.0.9 - this IP address is part of the liberreto TINC vpn mesh network. | The RPI can be accessed from [[RevRadio2]] via IP address 172.19.0.9 - this IP address is part of the liberreto TINC vpn mesh network. | ||
---- | |||
==Hardware== | ==Hardware== | ||
| Line 31: | Line 39: | ||
== settings for radio == | == <strike>old</strike> settings for the radio == | ||
[[File:Instellingen_alan48+.jpg]] | [[File:Instellingen_alan48+.jpg]] | ||
== oude todo == | |||
== | |||
** Anti-kabelsalade keuze: installatiekast | ** Anti-kabelsalade keuze: installatiekast | ||
*** Hier een mooie aan uit knop op voor als de zender uit moet (maar rpi aan mag blijven) | *** Hier een mooie aan uit knop op voor als de zender uit moet (maar rpi aan mag blijven) | ||
| Line 45: | Line 50: | ||
** APRS iGate: send all incoming aprs packets to [http://www.cbaprs.de/ cbaprs.de] | ** APRS iGate: send all incoming aprs packets to [http://www.cbaprs.de/ cbaprs.de] | ||
*** Direwolf sound card tnc? | *** Direwolf sound card tnc? | ||
** | ** MQTT gateway rx/tx | ||
Latest revision as of 22:05, 12 August 2016
| Project Packet radio | |
|---|---|
| hoe meer elektromagnetische velden, hoe meer vreugd | |
| Status | In progress |
| Contact | Flok420, Maxell, Crashjuh |
| Last Update | 2016-08-12 |
Tsja, 1200 baud… Gewoon omdat het kan!
----
Direwolf 1.3 - TX beacon voor nu - binnenkort audio-in klussen!
Networking
packetacer laptop: revspace@2001:610:76a:0:c646:19ff:fe57:e595
Currently the rpi is connected to a gl-inet (owned by Flok). The gl-inet is a client for revspace-pub. The gl-inet has a port-forward to the rpi.
IP address of the gl-inet: 10.42.43.217
MAC address of the gl-inet: e4:95:6e:40:2c:34
Currently the rpi is connected directly to the revspace network.
IP address of the raspberry pi: 10.42.43.49
MAC address of the raspberry pi: b8:27:eb:2b:a2:f9
The RPI can be accessed from RevRadio2 via IP address 172.19.0.9 - this IP address is part of the liberreto TINC vpn mesh network.
Hardware
We have an TNC-PI which is a TNC connected to a Raspberry Pi interfaced to a Midland Alan 48 plus (27 MHz) radio. Every five (5) minutes it sends out a beacon of information about the setup and the request to report back any receptions. Any incoming packets are being logged to the disk. If an incoming packet appears to be an APRS packet, it should get digipeated.
old settings for the radio
oude todo
- Anti-kabelsalade keuze: installatiekast
- Hier een mooie aan uit knop op voor als de zender uit moet (maar rpi aan mag blijven)
- Anti-kabelsalade keuze: installatiekast
- Add functionality
- APRS iGate: send all incoming aprs packets to cbaprs.de
- Direwolf sound card tnc?
- MQTT gateway rx/tx
- APRS iGate: send all incoming aprs packets to cbaprs.de