Packet radio: Difference between revisions

From RevSpace
Jump to navigation Jump to search
No edit summary
 
(20 intermediate revisions by 3 users not shown)
Line 2: Line 2:
  |Name=Packet radio
  |Name=Packet radio
  |Status=In progress
  |Status=In progress
  |Contact=flok
  |Contact=Flok420
|Contact1=Maxell
|Contact2=Crashjuh
|Omschrijving=hoe meer elektromagnetische velden, hoe meer vreugd
}}
}}


Fiddling with packet radio. The idea is to have a node/repeater/bbs/etc on at least 27mc, maybe other frequencies as well. In revspace and in [[Flok]]'s house (in Gouda).
Tsja, 1200 baud… Gewoon omdat het kan!
<strike>----
Direwolf 1.3 - TX beacon voor nu - binnenkort audio-in klussen!</strike>


==Currently running==
 
We have an [http://tnc-x.com/TNCPi.htm TNC-PI] which is a TNC connected to a raspberry pi interfaced to a Midland Allan 48 plus (27 MHz) radio. All this (sadly, also the antenna) is running in het kantoortje.
 
== Networking ==
packetacer laptop: revspace@2001:610:76a:0:c646:19ff:fe57:e595
----
<strike>
Currently the rpi is connected to a gl-inet (owned by [[Flok]]). The gl-inet is a client for revspace-pub. The gl-inet has a port-forward to the rpi.
 
IP address of the gl-inet: 10.42.43.217
 
MAC address of the gl-inet: e4:95:6e:40:2c:34
</strike>
 
Currently the rpi is connected directly to the revspace network.
 
IP address of the raspberry pi: 10.42.43.49
 
MAC address of the raspberry pi: b8:27:eb:2b:a2:f9
 
The RPI can be accessed from [[RevRadio2]] via IP address 172.19.0.9 - this IP address is part of the liberreto TINC vpn mesh network.
----
 
==Hardware==
We have an [http://tnc-x.com/TNCPi.htm TNC-PI] which is a TNC connected to a Raspberry Pi interfaced to a Midland Alan 48 plus (27 MHz) radio.
Every five (5) minutes it sends out a beacon of information about the setup and the request to report back any receptions. Any incoming packets are being logged to the disk. If an incoming packet appears to be an APRS packet, it should get digipeated.
Every five (5) minutes it sends out a beacon of information about the setup and the request to report back any receptions. Any incoming packets are being logged to the disk. If an incoming packet appears to be an APRS packet, it should get digipeated.


==Todo/ideas/plans==
 
Increase range: setup the antenna on the roof. This requires some metalwork since our initial antenna-mount is full.
== <strike>old</strike> settings for the radio ==
 
[[File:Instellingen_alan48+.jpg]]
 
== oude todo ==
** Anti-kabelsalade keuze: installatiekast
*** Hier een mooie aan uit knop op voor als de zender uit moet (maar rpi aan mag blijven)
 
* Add functionality
* Add functionality
** APRS iGate: send all incoming aprs packets to [http://www.cbaprs.de/]
** APRS iGate: send all incoming aprs packets to [http://www.cbaprs.de/ cbaprs.de]
** BBS: could be interesting just for the sake of moar RF
*** Direwolf sound card tnc?
** MQTT gateway rx/tx

Latest revision as of 22:05, 12 August 2016

Project Packet radio
hoe meer elektromagnetische velden, hoe meer vreugd
Status In progress
Contact Flok420, Maxell, Crashjuh
Last Update 2016-08-12

Tsja, 1200 baud… Gewoon omdat het kan! ---- Direwolf 1.3 - TX beacon voor nu - binnenkort audio-in klussen!


Networking

packetacer laptop: revspace@2001:610:76a:0:c646:19ff:fe57:e595

Currently the rpi is connected to a gl-inet (owned by Flok). The gl-inet is a client for revspace-pub. The gl-inet has a port-forward to the rpi.

IP address of the gl-inet: 10.42.43.217

MAC address of the gl-inet: e4:95:6e:40:2c:34

Currently the rpi is connected directly to the revspace network.

IP address of the raspberry pi: 10.42.43.49

MAC address of the raspberry pi: b8:27:eb:2b:a2:f9

The RPI can be accessed from RevRadio2 via IP address 172.19.0.9 - this IP address is part of the liberreto TINC vpn mesh network.

Hardware

We have an TNC-PI which is a TNC connected to a Raspberry Pi interfaced to a Midland Alan 48 plus (27 MHz) radio. Every five (5) minutes it sends out a beacon of information about the setup and the request to report back any receptions. Any incoming packets are being logged to the disk. If an incoming packet appears to be an APRS packet, it should get digipeated.


old settings for the radio

Instellingen alan48+.jpg

oude todo

    • Anti-kabelsalade keuze: installatiekast
      • Hier een mooie aan uit knop op voor als de zender uit moet (maar rpi aan mag blijven)
  • Add functionality
    • APRS iGate: send all incoming aprs packets to cbaprs.de
      • Direwolf sound card tnc?
    • MQTT gateway rx/tx
Retrieved from ‘https://revspace.nl/wiki/index.php?title=Packet_radio&oldid=9837’