Packet radio: Difference between revisions
(Created page with "Fiddling with packet radio. The idea is to have a node/repeater/bbs/etc on at least 27mc, maybe other frequencies as well. In revspace and in Flok's house (in Gouda). Cur...") |
|||
| (22 intermediate revisions by 4 users not shown) | |||
| Line 1: | Line 1: | ||
{{Project | |||
|Name=Packet radio | |||
|Status=In progress | |||
|Contact=Flok420 | |||
|Contact1=Maxell | |||
|Contact2=Crashjuh | |||
|Omschrijving=hoe meer elektromagnetische velden, hoe meer vreugd | |||
}} | |||
Currently | Tsja, 1200 baud… Gewoon omdat het kan! | ||
<strike>---- | |||
Direwolf 1.3 - TX beacon voor nu - binnenkort audio-in klussen!</strike> | |||
== Networking == | |||
packetacer laptop: revspace@2001:610:76a:0:c646:19ff:fe57:e595 | |||
---- | |||
<strike> | |||
Currently the rpi is connected to a gl-inet (owned by [[Flok]]). The gl-inet is a client for revspace-pub. The gl-inet has a port-forward to the rpi. | |||
IP address of the gl-inet: 10.42.43.217 | |||
MAC address of the gl-inet: e4:95:6e:40:2c:34 | |||
</strike> | |||
Currently the rpi is connected directly to the revspace network. | |||
IP address of the raspberry pi: 10.42.43.49 | |||
MAC address of the raspberry pi: b8:27:eb:2b:a2:f9 | |||
The RPI can be accessed from [[RevRadio2]] via IP address 172.19.0.9 - this IP address is part of the liberreto TINC vpn mesh network. | |||
---- | |||
==Hardware== | |||
We have an [http://tnc-x.com/TNCPi.htm TNC-PI] which is a TNC connected to a Raspberry Pi interfaced to a Midland Alan 48 plus (27 MHz) radio. | |||
Every five (5) minutes it sends out a beacon of information about the setup and the request to report back any receptions. Any incoming packets are being logged to the disk. If an incoming packet appears to be an APRS packet, it should get digipeated. | |||
== <strike>old</strike> settings for the radio == | |||
[[File:Instellingen_alan48+.jpg]] | |||
== oude todo == | |||
** Anti-kabelsalade keuze: installatiekast | |||
*** Hier een mooie aan uit knop op voor als de zender uit moet (maar rpi aan mag blijven) | |||
* Add functionality | |||
** APRS iGate: send all incoming aprs packets to [http://www.cbaprs.de/ cbaprs.de] | |||
*** Direwolf sound card tnc? | |||
** MQTT gateway rx/tx | |||
Latest revision as of 22:05, 12 August 2016
| Project Packet radio | |
|---|---|
| hoe meer elektromagnetische velden, hoe meer vreugd | |
| Status | In progress |
| Contact | Flok420, Maxell, Crashjuh |
| Last Update | 2016-08-12 |
Tsja, 1200 baud… Gewoon omdat het kan!
----
Direwolf 1.3 - TX beacon voor nu - binnenkort audio-in klussen!
Networking
packetacer laptop: revspace@2001:610:76a:0:c646:19ff:fe57:e595
Currently the rpi is connected to a gl-inet (owned by Flok). The gl-inet is a client for revspace-pub. The gl-inet has a port-forward to the rpi.
IP address of the gl-inet: 10.42.43.217
MAC address of the gl-inet: e4:95:6e:40:2c:34
Currently the rpi is connected directly to the revspace network.
IP address of the raspberry pi: 10.42.43.49
MAC address of the raspberry pi: b8:27:eb:2b:a2:f9
The RPI can be accessed from RevRadio2 via IP address 172.19.0.9 - this IP address is part of the liberreto TINC vpn mesh network.
Hardware
We have an TNC-PI which is a TNC connected to a Raspberry Pi interfaced to a Midland Alan 48 plus (27 MHz) radio. Every five (5) minutes it sends out a beacon of information about the setup and the request to report back any receptions. Any incoming packets are being logged to the disk. If an incoming packet appears to be an APRS packet, it should get digipeated.
old settings for the radio
oude todo
- Anti-kabelsalade keuze: installatiekast
- Hier een mooie aan uit knop op voor als de zender uit moet (maar rpi aan mag blijven)
- Anti-kabelsalade keuze: installatiekast
- Add functionality
- APRS iGate: send all incoming aprs packets to cbaprs.de
- Direwolf sound card tnc?
- MQTT gateway rx/tx
- APRS iGate: send all incoming aprs packets to cbaprs.de