LoraWanNode: Difference between revisions
Jump to navigation
Jump to search
(Created page with " {{Project |Name=LoraWanNode |Picture=plaatje dat je geupload hebt op de wiki |Omschrijving=Description of how to set up an Arduino Pro Mini and an HopeRF RFM95 to c...") |
(Initial content) |
||
Line 6: | Line 6: | ||
|Contact=bertrik | |Contact=bertrik | ||
}} | }} | ||
== Introduction == | |||
This page describes the steps needed to create a simple LoraWAN node for the-things-network. | |||
I've tested this on the TTN in the city of Utrecht. | |||
== Hardware == | |||
The hardware I've used is: | |||
* a HopeRF RFM95 module | |||
* an Arduino mini pro, 8MHz/3.3V | |||
* a CP2104-based serial-USB converter | |||
The HopeRF RFM95 module is connected to the Arduino as follows: | |||
* pin VCC to arduino Vcc pin (3.3V) | |||
* pin GND to arduino Gnd pin | |||
* pin NSS to arduino pin D10 | |||
* pin SCK to arduino pin D13 | |||
* pin MOSI to arduino pin D11 | |||
* pin MISO to arduino pin D12 | |||
* pin DIO0 to arduino pin D4 | |||
* pin DIO1 to arduino pin D5 | |||
* pin DIO2 to arduino pin D7 | |||
== Software == | |||
Tools: | |||
* Arduino IDE 1.6.8 | |||
=== Libraries === | |||
I've used this version of the LoRa LMIC library: https://github.com/things4u/LoRa-LMIC-1.51.git |
Revision as of 16:23, 3 April 2016
Project LoraWanNode | |
---|---|
350px | |
Description of how to set up an Arduino Pro Mini and an HopeRF RFM95 to create a LoraWAN node | |
Status | Initializing |
Contact | bertrik |
Last Update | 2016-04-03 |
Introduction
This page describes the steps needed to create a simple LoraWAN node for the-things-network.
I've tested this on the TTN in the city of Utrecht.
Hardware
The hardware I've used is:
- a HopeRF RFM95 module
- an Arduino mini pro, 8MHz/3.3V
- a CP2104-based serial-USB converter
The HopeRF RFM95 module is connected to the Arduino as follows:
- pin VCC to arduino Vcc pin (3.3V)
- pin GND to arduino Gnd pin
- pin NSS to arduino pin D10
- pin SCK to arduino pin D13
- pin MOSI to arduino pin D11
- pin MISO to arduino pin D12
- pin DIO0 to arduino pin D4
- pin DIO1 to arduino pin D5
- pin DIO2 to arduino pin D7
Software
Tools:
- Arduino IDE 1.6.8
Libraries
I've used this version of the LoRa LMIC library: https://github.com/things4u/LoRa-LMIC-1.51.git