LoRa-E5-mini: Difference between revisions

From RevSpace
Jump to navigation Jump to search
Line 13: Line 13:
* use platformio as the build system
* use platformio as the build system
* create some basic examples for use as a LoRaWAN node on TheThingsNetwork
* create some basic examples for use as a LoRaWAN node on TheThingsNetwork
Interesting post about this module:
https://www.disk91.com/2021/technology/lora/lora-e5-the-seeed-studio-stm32-wl-module/


=== Hardware ===
=== Hardware ===

Revision as of 22:46, 8 October 2021

Project LoRa E5
Arduino on the LoRa-E5 module
Status In progress
Contact bertrik
Last Update 2021-10-08

The plan

This page is about the LoRa-E5 module and getting it to work as a LoRaWAN node with Arduino and the BasicMac stack.

  • replace the original "AT" firmware with Arduino based firmware
  • use the BasicMac library for LoRaWAN
  • use platformio as the build system
  • create some basic examples for use as a LoRaWAN node on TheThingsNetwork

Interesting post about this module: https://www.disk91.com/2021/technology/lora/lora-e5-the-seeed-studio-stm32-wl-module/

Hardware

The hardware is the LoRa-E5 module from seeed studio, contains the STM32WLE5JC:

Overview of pins used on this board (not completely standard): https://wiki.seeedstudio.com/LoRa_E5_mini/#22-gpio-configuration-overview

Programming an STM32 is done with pins SWDIO (PA13), SWCLK (PA14), GND and VCC

Software

https://github.com/bertrik/lora-e5

There appears to be support for various kinds of WL55 boards: https://github.com/stm32duino/Arduino_Core_STM32/blob/main/boards.txt

Support for this board in this archive: https://github.com/dolfandringa/Arduino_Core_STM32/blob/master/variants/STM32WLxx/WL54JCI_WL55JCI_WLE4J(8-B-C)I_WLE5J(8-B-C)I/boards_entry.txt#L62  ???

Development environment

Node configuration in TheThingsNetwork

The information on the website of Seeed studios is outdated. It refers to the "v2" version of TheThingsNetwork, which is being phased out. It is already impossible to add new nodes on TTNv2, since it was set to read-only.

Nodes should be configured for TheThingsNetwork v3 instead.