CJMCU-811: Difference between revisions
Jump to navigation
Jump to search
Created page with "{{Project |Name=CJMCU-811 |Picture=plaatje dat je geupload hebt op de wiki |Omschrijving=Playing around with a breakout board for the CSS-811 IC |Status=Initializing |Con..." |
No edit summary |
||
| Line 1: | Line 1: | ||
{{Project | {{Project | ||
|Name=CJMCU-811 | |Name=CJMCU-811 | ||
|Picture= | |Picture=cjmcu811.jpg | ||
|Omschrijving=Playing around with a breakout board for the CSS-811 IC | |Omschrijving=Playing around with a breakout board for the CSS-811 IC | ||
|Status=Initializing | |Status=Initializing | ||
Revision as of 09:14, 30 December 2018
| Project CJMCU-811 | |
|---|---|
| |
| Playing around with a breakout board for the CSS-811 IC | |
| Status | Initializing |
| Contact | bertrik |
| Last Update | 2018-12-30 |
Introduction
I bought this breakout board from Aliexpress.
The CCS-811 is an air quality sensor chip by AMS.
Pins:
- VCC connect this to 3.3V (!)
- GND to ground obviously
- SCL to ESP
- SDA
- WAK this needs to be low (!) in order for the chip to be active
- INT can be left unconnected
- RST can be left unconnected
- ADD can be left unconnected
My board was apparently configured at I2C address 0x5A.