SpaceBlaster: verschil tussen versies
Uit RevSpace
Geen bewerkingssamenvatting |
|||
| Regel 11: | Regel 11: | ||
[[Image:SpaceBlaster.jpg|400px]] | [[Image:SpaceBlaster.jpg|400px]] | ||
== Status update 20-11 == | == Status update 20-11-2016 == | ||
One tri-state switch has been connected, I will use two GPIO pins to detect in which state the switch is to save GPIO pins. | |||
[[Image:SpaceBlaster_sp3t.jpg|400px]] | [[Image:SpaceBlaster_sp3t.jpg|400px]] | ||
Possible layout of the ARM board, arduino and amplifier. | Possible layout of the ARM board, arduino and amplifier. | ||
[[Image:Spaceblaster_layout_boards.jpg|400px]] | [[Image:Spaceblaster_layout_boards.jpg|400px]] | ||
Wago's are used on the other side for the ground / power | Wago's are used on the other side for the ground / power to avoid cable clutter mess :) | ||
Cable mgmt: | |||
* Blue cable => potentiometer | |||
* Black => Ground | |||
* Red => 5V | |||
[[Image:Spaceblaster_wagos_ftw.jpg|400px]] | [[Image:Spaceblaster_wagos_ftw.jpg|400px]] | ||
Versie van 20 nov 2016 03:30
| Project SpaceBlaster | |
|---|---|
| |
| Speaker soundsystem | |
| Status | Initializing |
| Contact | Jelly |
| Last Update | 2016-11-20 |
The SpaceBlaster is the ideal hackerspace portable speaker soundsystem. It's the competitor of the DeBASS and the DeCRASH.
Status update 20-11-2016
One tri-state switch has been connected, I will use two GPIO pins to detect in which state the switch is to save GPIO pins.
Possible layout of the ARM board, arduino and amplifier.
Wago's are used on the other side for the ground / power to avoid cable clutter mess :)
Cable mgmt:
- Blue cable => potentiometer
- Black => Ground
- Red => 5V
