Bestand:Plant board top.jpg: verschil tussen versies
Uit RevSpace
The board was a bit small for this project, but all fits. The whole thing uses the magic of the 4093 (a quad, dual input, Schmitt-trigger NAND port IC). It feeds the feelers (green pins) with a low current AC, then checks whether or not the voltage is hig |
Addig to category |
||
| Regel 1: | Regel 1: | ||
The board was a bit small for this project, but all fits. The whole thing uses the magic of the 4093 (a quad, dual input, Schmitt-trigger NAND port IC). It feeds the feelers (green pins) with a low current AC, then checks whether or not the voltage is high enough to trigger the next gate. Then a diode detector that converts the pulses to a nice DC level. This is available on the yellow pin for further processing. The last port of the 4093 is used to blink the LED. | The board was a bit small for this project, but all fits. The whole thing uses the magic of the 4093 (a quad, dual input, Schmitt-trigger NAND port IC). It feeds the feelers (green pins) with a low current AC, then checks whether or not the voltage is high enough to trigger the next gate. Then a diode detector that converts the pulses to a nice DC level. This is available on the yellow pin for further processing. The last port of the 4093 is used to blink the LED. | ||
Power is applied to red and blue, 4-5V is perfect, but even 15V should work! (The LED might die though!) | Power is applied to red and blue, 4-5V is perfect, but even 15V should work! (The LED might die though!) [[Category:Pictures]] | ||
Huidige versie van 2 jul 2017 19:54
The board was a bit small for this project, but all fits. The whole thing uses the magic of the 4093 (a quad, dual input, Schmitt-trigger NAND port IC). It feeds the feelers (green pins) with a low current AC, then checks whether or not the voltage is high enough to trigger the next gate. Then a diode detector that converts the pulses to a nice DC level. This is available on the yellow pin for further processing. The last port of the 4093 is used to blink the LED.
Power is applied to red and blue, 4-5V is perfect, but even 15V should work! (The LED might die though!)
Bestandsgeschiedenis
Klik op een datum/tijd om het bestand te zien zoals het destijds was.
| Datum/tijd | Miniatuur | Afmetingen | Gebruiker | Opmerking | |
|---|---|---|---|---|---|
| huidige versie | 19 sep 2013 06:11 |  | 600 × 291 (63 kB) | Glu (overleg | bijdragen) | The board was a bit small for this project, but all fits. The whole thing uses the magic of the 4093 (a quad, dual input, Schmitt-trigger NAND port IC). It feeds the feelers (green pins) with a low current AC, then checks whether or not the voltage is hig |
U kunt dit bestand niet overschrijven.
Bestandsgebruik
Dit bestand wordt op de volgende pagina gebruikt:
