Vacuumpomp

From RevSpace
Revision as of 18:49, 21 July 2021 by Thomas (talk | contribs)
Jump to navigation Jump to search
Project Vacuumpomp
Rebuilding a vacuum pump
Status In progress
Contact thomas
Last Update 2021-07-21

Leybold Trivac D8B

We need a roughing pump for our turbos. I bought this unit a while ago, and it works, but it also makes funny noises.

Plan

It needs to be opened up. I may have to fabricate and/or purchase some new parts to get it back to a more usable state.

Teardown / Rebuild

Lessons learned so far:

  • For those who wish to replace the shaft seals without being extorted by Leybold, they are regular FKM GR 15x24x6.5 SS 304 spring oil seals. Available as a general commodity item.
  • Use a special driver to install the new shaft seals. I designed one, you can find the STL here.
  • Do not try to replace the gas ballast seal unless absolutely necessary. It is very hard to remove from its deep, blind hole. It also incorporates an internal metal ring, making cutting the seal out impossible. See gallery photo above. It took me three hours to remove it without damaging the seat, with a combination of solvents, a scalpel and a hemostat. Don't be me, leave it be.
  • If the vanes seem a bit loose when dry, like they have too much play in the rotor slots and wobble around a bit, don't worry. Once there is an oil film between the vanes and the rotor surfaces, they'll be just fine.
  • Find the silencer nozzle on the detailed diagram and unclog that bastard. I am 99% sure this was the cause of the noise that prompted the rebuild. Its job is to inject a tiny bit of air into the second stage vane chamber, to keep it from making excessive noise when the pump reaches final pressure. The orifice is incredibly small. I used a thread from some stranded wire to unclog it. Be careful though, it is made of aluminium for some reason.