VINDRIKTNING: Difference between revisions

From RevSpace
Jump to navigation Jump to search
Line 27: Line 27:
https://threadreaderapp.com/thread/1415291684569632768.html
https://threadreaderapp.com/thread/1415291684569632768.html


=== Interfacing with ESP8266 ===
The datasheet of the PM1006K mentions that it takes 5V as power and communicates using 4.5V levels.
The datasheet of the PM1006K mentions that it takes 5V as power and communicates using 4.5V levels.
The reverse-engineered schematic shows resistors in line with the RX and TX lines.
The reverse-engineered schematic shows resistors in line with the RX and TX lines.

Revision as of 07:27, 18 July 2021

Project VINDRIKTNING
VINDRIKTNING.png
Hacking IKEA VINDRIKTNING PM2.5 indicator
Status In progress
Contact bertrik
Last Update 2021-07-18

What

This page is about hacking the IKEA VINDRIKTNING PM2.5 indicator light.

Hardware

  • power is by USB-C probably 5V
  • the particulate matter sensor is the Cubic PM1006K
  • appears to have two LEDs (red and green) so it can indicate colours green, orange and red
  • the sensor output can be PWM or UART, the UART output provides PM1.0 PM2.5 and PM10 values

Pictures of its internals: https://twitter.com/guido_burger/status/1413900622919872521

  • there is a footprint for a kind of debug header, with signals ISPDA, RESET, ISPCLK, GND, +5V
  • there is an internal header with signals LED_G_1, PWM_Fan, LED_R_1, FAN-, FAN+
  • there is a separate header for the fan with signals FAN+,FAN-
  • there is an 8-pin IC, could this be the "main" microcontroller?
  • there is a light-sensing element, that controls the brightness of the LED

More pictures of its internals, with reverse-engineered schematics: https://threadreaderapp.com/thread/1415291684569632768.html

Interfacing with ESP8266

The datasheet of the PM1006K mentions that it takes 5V as power and communicates using 4.5V levels. The reverse-engineered schematic shows resistors in line with the RX and TX lines. An ESP8266 should be 5V tolerant. This means that it is probably possible to directly connect an ESP8266 in place of the original microcontroller.

Hacking

The microcontroller is an ES7P001.

Find out if it can be read out, perhaps reprogram it.

Idea: by default, the light only shows one quality indicator, but the particulate matter sensor datasheet shows that it can output PM1.0, PM2.5 and PM10 values too. You could fit an ESP8266 that reads out the raw PM categories and publish them over WiFi, e.g. using a home assistant compatible protocol.

Software

Some intial, untested code for an ESP8266 (Wemos D1 mini) to communicate with the PM1006K sensor inside this device can be found at https://github.com/bertrik/pm1006k

The hardware probably needs a level shifter in line with the RX and TX signals.