TIX clock

From RevSpace
Revision as of 17:13, 19 January 2020 by Noor (talk | contribs)
Jump to navigation Jump to search
Project TIX clock
2019-11-15 181501 - DSC06467.jpg
Status In progress
Contact Noor, bertrik
Last Update 2020-01-19

Have an 'original' TIX clock (YouTube video) from ThinkGeek.

Could also be programmed to display any number up to 4 digits, but the design is best suited for displaying time (blocks are in sets of 3, 9, 6, 9).

Reverse engineering

There are a total of 27 LEDs on the board, organised as 9 columns of 3 leds each. Each column has a shared cathode.

There are a total of 19 transistors on the board. Each column has its own transistor.

From left to right:

  • column: D27/D18/D9, cathode connected through 62 ohm to collector of Q11, which is controlled through 220 to IC pin 5 (RBx?)
  • column: D26/D17/D8, cathode connected through 62 ohm to collector of Q12, which is controlled through 220 to IC pin 6 (RB0)
  • column: D25/D16/D7, cathode connected through .. to collector of Q13, which is controlled through ... to IC pin 7 (RB1)
  • column: D24/D15/D6, cathode connected through .. to collector of ..., which is controlled through ... to IC pin 9 (RB3)
  • column: D23/D14/D5, ... IC pin 10 (RB4)
  • column: D22/D13/D4, ... IC pin 11 (RB5)
  • column: D21/D12/D3, ... IC pin 12 (RB6)
  • column: D20/D11/D2, ... IC pin 13 (RB7)
  • column: D19/D10/D1, ... IC pin 15 (RA6)

Rows:

  • D27/D26/D25/D19, D24/D23, D22/D21/D20
  • D18/D17/D16/D10, D15/D14, D13/D12/D11
  • D9/D8/D7/D1, D6/D5, D4/D3/D2

D13 cathode goes to D12 cathode, goes to Q5 collector, Q5 base goes to R5, R5 goes to

Timeline

2019-11

Changed out the American plug for an EU one, but the clock requires 60 Hz AC, and 50 Hz will make it run slow and thus useless for telling time.

2019-11-13 144638 - DSC06464.jpg 2019-11-15 180044 - DSC06465.jpg 2019-11-15 180508 - DSC06466.jpg 2019-11-15 181501 - DSC06467.jpg

2020-01-17 - 2019-01-20

From an old Tweakers thread: "Dus schoef je wekker eens open en google op het typenummer van de chip. 10 tegen 1 dat er een 60/50Hz-select pootje aanzit. Vaak is die verbonden met een draadbruggetje op de print; omsolderen en klaar!"

Looked into this but no luck. Best bet is to replace the chip (original PIC16F628A, with ESP8266?) and update time via wifi.

2020-01-18 182119 - DSC08511.jpg 2020-01-19 172607 - DSC08533.jpg

External links