Difference between revisions of "MiniSTM32F103ZE"

From RevSpace
Jump to navigation Jump to search
(Created page with "== Introduction == This page is about a development board named "CZ miniSTM32F103ZE-EK" found on Aliexpress. == Flashing the bootloader == To make it easy to upload software...")
 
Line 1: Line 1:
 +
  {{Project
 +
  |Name=MiniSTM32F103ZE
 +
  |Picture=ohnopicture.jpg
 +
  |Omschrijving=Making my miniSTM32F103ZE-EK board work
 +
  |Status=Initializing
 +
  |Contact=bertrik
 +
  }}
 +
 
== Introduction ==
 
== Introduction ==
This page is about a development board named "CZ miniSTM32F103ZE-EK" found on Aliexpress.
+
This page is about a development board named "CZ miniSTM32F103ZE-EK" found on Aliexpress and making it work.
  
 
== Flashing the bootloader ==
 
== Flashing the bootloader ==
Line 6: Line 14:
  
 
You need the stm32flash utility and a bootloader file for use with PE2.
 
You need the stm32flash utility and a bootloader file for use with PE2.
 +
Get them from the stm32duino page.
  
 
Steps to flash the bootloader:
 
Steps to flash the bootloader:
Line 21: Line 30:
  
 
If you now reset the board (e.g. press the reset button), you should be able to see the green LED flash.  
 
If you now reset the board (e.g. press the reset button), you should be able to see the green LED flash.  
 
 
You can now upload programs using the 'dfu' method.
 
You can now upload programs using the 'dfu' method.
  

Revision as of 18:18, 26 May 2018

Project MiniSTM32F103ZE
350px
Making my miniSTM32F103ZE-EK board work
Status Initializing
Contact bertrik
Last Update 2018-05-26

Introduction

This page is about a development board named "CZ miniSTM32F103ZE-EK" found on Aliexpress and making it work.

Flashing the bootloader

To make it easy to upload software over USB, I recommend you install the stm32duino bootloader.

You need the stm32flash utility and a bootloader file for use with PE2. Get them from the stm32duino page.

Steps to flash the bootloader:

  • wire a USB-serial converter to the board:
 serial GND -> board GND
 serial +5V -> board 5V
 serial RXD -> board A9
 serial TXD -> board A10
  • put jumper BOOT0 in position 1 (to 3.3V)
  • put jumper BOOT1 in position 0 (to GND)
  • reset or power-cycle the board
  • flash the bootloader using stm32flash:
 ./stm32flash -w ../../../../STM32duino-bootloader/binaries/generic_boot20_pe2.bin -v -g 0x0 /dev/ttyUSB0
  • power down the board, put BOOT0 jumper back in position 0 (to GND)

If you now reset the board (e.g. press the reset button), you should be able to see the green LED flash. You can now upload programs using the 'dfu' method.

Software

Software can be found on github.

platformio

The archive contains a platformio configuration.

To compile:

 pio run

To upload:

 pio run -t upload

To run:

 pio device monitor