Difference between revisions of "IbmPosDisplay"

From RevSpace
Jump to navigation Jump to search
(Upgrade status from "initializing" to "in progress")
Line 10: Line 10:
 
The display in question contains two rows of 20 characters each.
 
The display in question contains two rows of 20 characters each.
 
The characters on the display are of the [http://en.wikipedia.org/wiki/Vacuum_fluorescent_display VFD] type, in blue/cyan.
 
The characters on the display are of the [http://en.wikipedia.org/wiki/Vacuum_fluorescent_display VFD] type, in blue/cyan.
 +
 +
The display has the following markings:
 +
Futabacorp KU-02194V-O N
  
 
== Interface ==
 
== Interface ==

Revision as of 20:33, 21 March 2014

Project IbmPosDisplay
Status In progress
Contact bertrik
Last Update 2014-03-21

In this project, an old IBM point-of-sale (POS) display is reverse engineered to display arbitrary text. The goal of this project is not entirely clear.

The display in question contains two rows of 20 characters each. The characters on the display are of the VFD type, in blue/cyan.

The display has the following markings: Futabacorp KU-02194V-O N

Interface

The electrical interface to the display consists of 4 wires, possibly:

  • ground
  • data A (inverting), D-
  • data B (non-inverting), D+
  • power (12V) - red

This is most likely an RS485 interface, because there is a 75176 (differential bus transceiver) inside the display.

A very simple RS232-to-RS485 conversion can be done by simply biasing the inverting data pin (data A) to half the supply voltage, and connecting the RS232 data line directly to the non-inverting data pin (data B).

TODO

  • Figure out baud rate
  • Write software to control the display

External links

Possible protocol descriptions: