Difference between revisions of "Flipdot"

From RevSpace
Jump to navigation Jump to search
(50-pin connector)
(50-pin connector)
Line 15: Line 15:
  
 
== 50-pin connector ==
 
== 50-pin connector ==
[[File:flipdot_50pin_connector.png|thumb|the 50-pin connector]]
+
[[File:flipdot_50pin_connector.png|thumb|left|the 50-pin connector]]
 
There is a 50-wire cable going from the control board to the actual flipdot-boards.
 
There is a 50-wire cable going from the control board to the actual flipdot-boards.
The image to the side shows the pinout of the connector.
+
The image on the left shows the pinout of the connector.
  
 
=Serial werkend krijgen=
 
=Serial werkend krijgen=

Revision as of 23:30, 25 June 2018

Project FlipDot
SGoKHyK6TbG5VyLyKMMVBg.jpg
Status In progress
Contact User:Sebastius
Last Update 2018-06-25

Status

Het bord hangt aan de muur! Te bereiken via MQTT op topic revspace/flipdot

Controller

Schema

Project op github waarbij een LAWO display wordt aangestuurd door een STM32, met daarin o.a. een pinout van de 50-pins connector met zinnige namen, als ROW_H_0..15, ROW_L_0..15, COL_ADDR_1..4.

50-pin connector

the 50-pin connector

There is a 50-wire cable going from the control board to the actual flipdot-boards. The image on the left shows the pinout of the connector.

Serial werkend krijgen

0381C9273B09.jpg

Pin 2 en 3 van de 74HC14 loshalen. Daarna werken de RX en TX pins op het bord met een USB-Serial TTL. GND niet vergeten...

1200Baud, 7E2 (7 bits, Even Parity, 2 Stop bits)

stty -f /dev/ttyUSB0 1200 cs7 parenb -parodd cstopb

STTY blinkt niet uit in duidelijke parameters...

Code

Met dank aan Juerd:

#!/usr/bin/perl -w
use strict;
use autodie;
open my $fh, ">/dev/ttyUSB0";

my $bla = "regel 1\nregel 2";

my $output = "aA11000\n$bla\n\n\r";

my $xor = 0x7f;
$xor ^= ord for split //, $output;

$output .= chr $xor;
syswrite($fh, $output);

MQTT ESP

VDPxDd7bR3mCYU7mlO1W6w.jpg

Een NodeMCU hangt aan de serial. Code geschreven in Arduino. Er is een beter printje in bestelling om het netter op te lossen. De secundaire TX pin van de NodeMCU wordt gebruikt (GPIO 15) zodat bij een boot/reboot van de ESP het bord er geen last van heeft.

Reparatie

1 IC socket was verteerd door batterijschade. Ook de 4072 vervangen. Kloppen op het IC leverde een reboot namelijk.

B1mDBTYNSmOXexG3iw9wKw.jpg

Foto's

41EDFE20-B18A-4F13-89EB-838BC4CF7F17.jpg E0270E068FF3.jpg